Add Trim with Multi-hole Foot

Multi-hole foot stitching examples
Decorative Stitches over cords and yarn using a Multi-hole foot

 

 

Whether it comes with your machine, or you purchase it as an accessory, this little foot creates lots of stitching fun!

The multi-hole foot, or multi-cord foot has either holes in the surface or channels under it that allow you to feed multiple strands of specialty threads, small cords, yarns, metallics, ribbons, etc. through them for couching. The foot keeps all the strands parallel for you while you stitch.

Courtesy of Pfaff
Courtesy of Pfaff

Depending on the brand, you may be able to couch over three, five, seven or nine strands at once. Strands can be all the same color, or totally different colors, and you can create a secondary pattern by the sequencing of colors. For example, put darker strands along the outside and lighter ones in the center.

Create a pattern with different colors of cord- Courtesy of Husqvarna Viking
Create a pattern with different colors of cord- Courtesy of Husqvarna Viking

If you thread the machine needle with Coats Polyester Embroidery thread, Coats Machine Quilting thread, or even regular Dual Duty XP all-purpose sewing thread in a contrast color, the stitching becomes a prominent part of the couched design. For fun, try a Coats Thread in a multi-color.  If you prefer to let the strands show their stuff, then thread the machine with Coats Transparent  thread.

Coats Transparent Polyester Thread- Clear
Coats Transparent Polyester Thread- Clear
Coats Cotton Multi color Thread
Coats Cotton Multi color Thread

 

 

 

 

 

 

 

A zigzag or almost any open decorative stitch can be used, but be sure the stitch width covers all the strands for maximum hold. On some fabrics it may be necessary to add stabilizer under the stitching to prevent puckering.

Courtesy of Husqvarna Viking
Courtesy of Husqvarna Viking

Stitch slowly as you’re guiding multiple strands at one time—either following a design line marked on your fabric or free-form.

If the design line doesn’t end in a seam, thread each strand through to the underside and knot, or extend the ends and tie them into a knot or tassel for additional decoration.

TIP: If your machine brand has a foot with holes in it, use a wire needle threader to pull each strand through the top of the foot. On machines with channels, simply open the latch to lay in the strands in order, then snap closed for stitching.

 

Foot with Latch Open- Courtesy of Bernina
Foot with Latch Open- Courtesy of Bernina
Courtesy of Pfaff
Courtesy of Pfaff

 

2 thoughts on “Add Trim with Multi-hole Foot

    • lynnbrowne Post authorReply

      We recommend using an all-purpose thread like Dual Duty XP on the bobbin in a color to match the project.

Leave a Reply

Your email address will not be published. Required fields are marked *